SMTA International Conference Proceedings


Low Temperature Solder Interconnect Reliability and Potential Application in Enterprise Computer and Automotive Electronics

Authors: Paul Wang, Ph.D., David He, Vivi Cao, and Jason Su
Company: MiTAC Computer Corp.
Date Published: 10/14/2018   Conference: SMTA International


Abstract: Journal Nature of June 14, 2018 report that the Antarctic ice sheet lost nearly three trillion metric tons of ice from 1992 to 20171. In just the last five years, the frozen continent has shed ice almost three times faster on average than it did over the previous 20 years. Combined all the water raised the global sea level by average 7.6mm, the researcher said about two-fifths of that rise occurred in the last five years. iNEMI Board Assembly Technical Roadmap2 of 2017 predict that the low temperature soldering (LTS) usage will increase to 20 plus percent by 2027. The drivers for this LTS technology trend are three folds, the energy and CO2 emission reduction, overcome material limitation in electronic component and PCB, and low soldering process to match with electronic miniaturization.

This article is a series of study on new low melting temperature solder interconnect application and reliability on various product categories, enterprise computers such as server and storage, AIO (all-in-one desk top), POS (Point of Sale), tablet, and automotive electronics. First, the raw LTS SnBiAg material properties range from power particle size, Halogen content, flux characterization, viscosity, wetting, SIR, Electrochemical migration etc. are assessed. Then five product emulators are selected as test vehicle to represent the broad scope of various electronics products. Due to the nature of brittleness of Bi contain in the LTS as shown in earlier publications3,4 the material drop cycle to failure reliability of LTS is substantially below current SAC305 which widely used in various electronics. Mechanical strengthening mechanism such as corner bonding material is attached along the BGA to observe the susceptibility of mechanical shock in later two product emulators, tablet and automotive electronics.

Since all BGA incoming with solder composition are in SAC305 nowadays there is a backward compatibility issue with new LTS. Inhomogeneous microstructure as well as potential solder defect was observed in SEM micrograph. Experiment of adding various LTS paste volume so as different Bi percentage in mixed alloy join are studied to see crack propagation and failure interface due to Bi diffusion and intermetallic compound formation when product emulator subject to accelerated stress test. While observe the crack propagation in microstructure, potential strengthening mechanism such as solid solution, precipitation hardening and phase size refinement can be determined in the of SAC and LTS mixed and Bi percentage variation alloy.

Finally BFT (board functional test) will be conducted in between accelerated thermal and mechanical cycling test to offline but real-time monitoring the reliability of solder joint of passive, PTH, BGA of active IC and CPU. The benefit of using product emulators with BFT is an advantage in the transition of LTS from SAC.

Key Words: 

LTS, Low Temperature Solder, SnBiAg, Technology Roadmap, Climate Change, Extreme Weather, Product Emulator, SAC305, Mixed alloy, Inhomogeneous microstructure, mixed alloy, Crack Propagation, Intermetallic Compound, Strengthening Mechanism



Members download articles for free:

Not a member yet?

What else do you get when you join SMTA? Read about all of the benefits that go along with membership.

Notice: Sharing of articles is restricted to just your immediate work group. Downloaded papers should not be stored on an external network or shared on the internet.


Back


SMTA Headquarters
6600 City West Parkway, Suite 300
Eden Prairie, MN 55344 USA

Phone +1 952.920.7682
Fax +1 952.926.1819