SMTA International Conference Proceedings

Voiding Control At QFN Assembly

Authors: Derrick Herron, Yan Liu, Ph.D., and Ning-Cheng Lee, Ph.D.
Company: Indium Corporation
Date Published: 10/16/2011   Conference: SMTA International

Abstract: Quad Flat No Leads (QFN) package designs receive more and more attention in electronic industry nowadays. This package offers a number of benefits including (1) small size, such as a near die-sized footprint, thin profile, and light weight; (2) easy PCB trace routing due to the use of perimeter I/O pads; (3) reduced lead inductance; and (4) good thermal and electrical performance due to the adoption of exposed copper die-pad technology. These features make the QFN an ideal choice for many new applications where size, weight, electrical, and thermal properties are important. However, adoption of QFN often runs into voiding issues at SMT assembly. Upon reflow, outgassing of solder paste flux at the large thermal pad has difficulty escaping and inevitably results in voiding. It is well known that the presence of voids will affect the mechanical properties of joints and deteriorate the strength, ductility, creep, and fatigue life. In addition, voids could also produce spot overheating, lessening the reliability of the joints. This is particularly a concern for QFN where the primary function of thermal pads is for heat dissipation. Thermal pad voiding control at QFN assembly is a major challenge due to the large coverage area, large number of via, and low standoff. Both design and process were studied for minimizing and controlling the voiding. For an open via situation, a full thermal pad is desired for a low number of via. For a large number of via, a divided thermal pad is preferred due to better venting capability. Placement of a via at the perimeter prevents voiding caused by via. A wider venting channel has a negligible effect on voiding and reduces joint continuity. For divided thermal pad, the SMD system is more favorable than the NSMD system, with the latter suffering more voiding due to a thinner solder joint and possibly board outgassing. Performance of a divided thermal pad is dictated by venting accessibility, not by the shape. Voiding reduction increases with increasing venting accessibility, although introduction of a channel area compromises the continuity of solder joint. Reduced solder paste volume causes more voiding. Short profiles and long hot profiles are most promising in reducing the voiding. Voiding behavior of a QFN is similar to typical SMT voiding and increases with pad oxidation and further reflow.

Key Words: 

QFN, void, solder, SMT, reflow, assembly

Members download articles for free:

Not a member yet?

What else do you get when you join SMTA? Read about all of the benefits that go along with membership.

Notice: Sharing of articles is restricted to just your immediate work group. Downloaded papers should not be stored on an external network or shared on the internet.


SMTA Headquarters
6600 City West Parkway, Suite 300
Eden Prairie, MN 55344 USA

Phone +1 952.920.7682
Fax +1 952.926.1819